Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the C1125 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The control unit computes the wheel rotating speed by the signal sent from the sensor. Then it supplies a DC current to the actuator solenoid valve. It also controls ON-OFF operation of the solenoid valve relay and motor relay. If any electrical malfunction should be detected in the system, the control unit causes the warning lamp to turn on. In this condition, the ABS will be deactivated by the control unit, and the vehicle's brake system reverts to normal operation.
The ABS actuator and electric unit (control unit) contains: An electric motor and pump, Two relays, Eight solenoid valves ( each inlet and outlet for LH front, RH front, LH rear, RH rear), and ABS control unit.
These components control the hydraulic circuit that increases, holds or decreases hydraulic pressure to all or individual wheels. The ABS actuator and electric unit (control unit) cannot be disassembled and must be replaced as an assembly.
Need more information on how to fix the C1125 code? Get Access to Factory Service Manuals
Get the C1125 code diagnosed by a professional: Find a repair shop in your area