Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the C1220 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The Electronic Brake Control Module uses inputs from the Electronic Brake Control Brake Pedal Position Sensor to determine when the brake is applied and how much force is used. The Electronic Brake Control Module monitors when the driver's foot is on the brake and locks the offset. The offset is locked when three out of the four inputs indicate the brake pedal is applied. The four inputs are brake pedal travel 1, brake pedal travel 2, master cylinder pressure sensor, and brake pedal position sensor. These inputs are used to determine the driver's braking intent which is used to control the amount of pressure applied to the wheels.
Brake pressure sensor information is communicated from the Electronic Brake Control Module (EBCM) to the Hybrid Control Processor (HCP). This information is used to schedule regenerative braking and engine autostops.
The Diagnostic Trouble Code (DTC) will be set when the Engine Control Module (ECM) detects a corrupted data message from the Electronic Brake Control Module.
Need more information on how to fix the C1220 code? Get Access to Factory Service Manuals
Get the C1220 code diagnosed by a professional: Find a repair shop in your area