P0101 Dodge - Mass Air Flow Sensor Performance
- Faulty mass air flow sensor
- Intake air leaks
- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor circuit poor electrical connection
Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
When is the code detected?
The Mass Air Flow (MAF) sensor value is less than 16Kg/h when the throttle valve angle is greater than 14 degs for approximately 5 seconds ,or MAF sensor reading is greater than a calculated value that is determined by engine speed and throttle valve angle.
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine stall
- Engine running rough
- Excessive fuel consumption
- Excessive smoke
P0101 Dodge Description
The Mass Air Flow (MAF) sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM).
The temperature of the hot film is controlled by the ECM a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.
Need more help?
Do you need more help with the P0101 Dodge code? ask a question to our users or search the top hand picked automotive forums for more information
Repair Shops Around Your Area
Need parts to fix this code? Search hundreds of stores at the same time and compare prices
Help us improve Engine-Codes.com. Leave a comment below or tell us if the information above help you fix the code. What are symptoms is your vehicle for the P0101 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks