The P0325 code means that the Knock Sensor is not working properly. Replacing the knock sensor usually takes care of the problem.
You maybe also consider replacing the knock sensor short harness to avoid future problems.
If you have a V6 Toyota Highlander, it is recommended you replace both knock sensors and short harness to avoid re-doing the labor since it is alot of work, since it is located under the intake manifold.
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the P0325 2005 Toyota Highlander code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
When an excessively low or high voltage from the sensor is sent to Engine Control Module (ECM)
The Knock Sensor (KS) senses engine knocking (also known as detonation or pinging) using a piezoelectric element. The sensor is attached to the cylinder block, cylinder head or intake manifold. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Engine Control Module (ECM). The ECM uses this signal to retard the ignition timing and protect the engine from this damaging pre-ignition.
Need more information on how to fix the P0325 2005 Toyota Highlander code? Get Access to Factory Service Manuals
Get the P0325 2005 Toyota Highlander code diagnosed by a professional: Find a repair shop in your area