P0335 Scion - Crankshaft Position Sensor 'A' Circuit
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
Sometimes and in some models, low battery voltage or a weak starter can can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replaced battery.
When is the code detected?
The crankshaft position sensor (POS) signal is not detected by the Electronic Control Module (ECM) during the first few seconds of engine cranking
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible lack/loss of Power
- Engine may stall while driving
P0335 Scion Description
The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
P0335 Scion Information for specific Scion models
Need more help?
Do you need more help with the P0335 Scion code? ask a question to our users or search the top hand picked automotive forums for more information
SCION Technical Service Bulletins for P0335 code
2009 SCION SCION XB Engine (pws) Details
Repair Shops Around Your Area
Need parts to fix this code? Search hundreds of stores at the same time and compare prices
Help us improve Engine-Codes.com. Leave a comment below or tell us if the information above help you fix the code. What are symptoms is your vehicle for the P0335 Scion code?
Have you replaced any parts?
Any information is appreciated. Thanks