Engine-Codes - Cadillac - P0337 Cadillac

P0337 Cadillac Code - Crankshaft Position Sensor Circuit Low Duty Cycle

- Code Popularity: 2,915 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0337 Cadillac?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty crankshaft position sensor
  • Crankshaft position sensor harness is open or shorted
  • Crankshaft position sensor circuit poor electrical connection
  • Signal plate may be damage
  • Starter motor may be faulty
  • Starting system circuit
  • Dead or weak battery
⚠ Does your Cadillac have Safety Recalls? → Check here

How to Fix the DTC P0337 Cadillac?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0337 Cadillac Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0337 Cadillac code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The crankshaft position sensor (POS) signal is not detected by the Powertrain Control Module (PCM) during the first few seconds of engine cranking

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine Cranks but Does Not Start
  • Lack/Loss of Power
  • Engine Stall

What Does the P0337 Cadillac Code Mean?

The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Powertrain Control Module (PCM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

P0337 Cadillac Code - Crankshaft Position Sensor Circuit Low Duty Cycle

Need more Information on the Code?

Need more information on how to fix the P0337 Cadillac code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0337 Cadillac code diagnosed by a professional: Find a repair shop in your area