P0340 Jeep - Camshaft Position Sensor Circuit Bank 1 Sensor 1
- Faulty Camshaft Position Sensor
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery
Sometimes and in some models, low battery voltage or a weak starter can can trigger a Camshaft Position Sensor code.
When is the code detected?
The camshaft position sensor signal is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- Engine Stall
P0340 Jeep Description
The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.
JEEP Technical Service Bulletins for P0340 code
2004 JEEP LIBERTY Electrical System: Software Details
2005 JEEP LIBERTY Electrical System: Software Details
2006 JEEP LIBERTY Electrical System: Software Details
2006 JEEP COMMANDER Electrical System: Software Details
2007 JEEP COMMANDER Power Train:automatic Transmission:control Module (tcm, Pcm) Details
2007 JEEP COMMANDER Electrical System: Software Details
2006 JEEP COMMANDER 4X2 Electrical System: Software Details
2005 JEEP GRAND CHEROKEE Electrical System: Software Details
2006 JEEP GRAND CHEROKEE Power Train:automatic Transmission:control Module (tcm, Pcm) Details
2006 JEEP GRAND CHEROKEE Electrical System: Software Details
Need more help?
Do you need more help with the P0340 Jeep code? ask a question to our users or search the top hand picked automotive forums for more information
Need parts to fix this code? Search hundreds of stores at the same time and compare prices
Help us improve Engine-Codes.com. Leave a comment below or tell us if the information above help you fix the code. What are symptoms is your vehicle for the P0340 Jeep code?
Have you replaced any parts?
Any information is appreciated. Thanks