Engine-Codes.com | All About OBDII Engine Codes
Engine-Codes.com | All About OBDII Engine Codes

P0475 Ford

P0475 Ford - Exhaust Pressure Control Valve Malfunction

PDF
P0475 Ford Comments |  Add Comment
Possible causes
- Faulty Exhaust Back Pressure Valve
- Exhaust Back Pressure Valve harness is open or shorted
- Exhaust Back Pressure Valve circuit poor electrical connection
Help with Possible causes What does this mean?
Tech notes
Check the Exhaust Back Pressure Valve (EBPV) butterfly valve is opening and closing freely and not sticking. If it seems to move freely you can then check the connector and circuit for the EBPV solenoid.
Help with Tech Notes What does this mean?
When is the code detected?
Problems with either the Exhaust Back Pressure (EBP) Device or the tube between the exhaust manifold and the EBP sensor can be detected during the exhaust back pressure step test, in which the Engine Control Module (ECM) commands and then measures a specific preprogrammed pressure and then measures time for pressure decay during the engine running test.

If the ECM detects an Exhaust Back Pressure (EBP), Engine Oil Temperature (EOT) or Intake Air Temperature (IAT) sensor fault it will disable the exhaust back pressure regulator.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0475 Ford Description

Exhaust Back Pressure Regulator - Is a variable position valve that controls exhaust back pressure during cold ambient temperatures to increase cab heat and decrease the amount of time needed to defrost the windshield. The Engine Control Module (ECM) uses the measured exhaust back pressure, (ambient) intake air temperature, engine oil temperature and engine load to determine the desired exhaust back pressure. Valve position is controlled by switching the output signal circuit to 12 volts inside the ECM. On/off time is modulated from 0 to 99 % dependent upon the exhaust back pressure desired.

Upon each initial engine start-up, the ECM exercises the exhaust back pressure valve by commanding it to cycle on and off once. If upon start-up the temperature of intake air sensed by the Intake Air Temperature (IAT) sensor is < 37°F (5°C) and the oil temperature sensed by the Engine Oil Temperature (EOT) sensor is between 32°-140°F (0-60°C) it will continue to keep the back pressure valve partially closed. As the oil temperature rises during engine operation, the ECM will control the valve in response to the rising oil temperature.

Need more help?
Do you need more help with the P0475 Ford code? ask a question to our users or search the top hand picked automotive forums for more information


(You will add more details to the question in the next step)
or
Need parts?
Need parts to fix this code? Search hundreds of stores at the same time and compare prices


Help Engine-Codes.com
Help us improve Engine-Codes.com. Leave a comment below or tell us if the information above help you fix the code. What are symptoms is your vehicle for the P0475 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks
Engine-Codes.com Comments Powered by Disqus
Google +