Engine-Codes - Infiniti - P0500 2005 Infiniti G35

P0500 2005 Infiniti G35 Code - Vehicle Speed Sensor

- Code Popularity: 4,028 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0500 2005 Infiniti G35?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Vehicle Speed Sensor
  • Vehicle speed sensor harness or connectors is open or shorted
  • Vehicle speed sensor circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

Code Tech Notes

On most Infiniti models the Vehicle Speed Sensor (VSS) is installed in the transaxle, on some Infiniti models poor connection at the speedometer can cause the problem. Before replacing the sensor you should try cleaning the sensor gear and erasing the code. If the light comes back you may have to replace the sensor.

⚠ Does your Infiniti have Safety Recalls? → Check here

How to Fix the DTC P0500 2005 Infiniti G35?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0500 2005 Infiniti G35 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0500 2005 Infiniti G35 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The almost 0 km/h (0 MPH) signal from vehicle speed sensor is sent to ECM even when vehicle is being driven.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Speedometer may not work properly
  • Transmission shifting problem

What Does the P0500 2005 Infiniti G35 Code Mean?

The vehicle speed sensor outputs a 4 pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the Engine Control Module (ECM). The ECM determines the vehicle speed based on the frequency of these pulse signals.
If P0500 is displayed with U1000 or U1001, first perform the trouble diagnosis for DTC U1000,U1001.

P0500 2005 Infiniti G35 Code - Vehicle Speed Sensor

Need more Information on the Code?

Need more information on how to fix the P0500 2005 Infiniti G35 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0500 2005 Infiniti G35 code diagnosed by a professional: Find a repair shop in your area