Engine-Codes - Volkswagen - P0703 Volkswagen

P0703 Volkswagen Code - Brake Switch 'B' Circuit

- Code Popularity: 10,590 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0703 Volkswagen?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Brake Switch
  • Brake Switch harness is open or shorted
  • Brake Switch circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

Code Tech Notes

Check if the stop light works when the brake pedal is depressed if the brake lights are inoperative, replace or adjust the Brake Switch (Stop Lamp Switch).

⚠ Does your Volkswagen have Safety Recalls? → Check here

How to Fix the DTC P0703 Volkswagen?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0703 Volkswagen Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0703 Volkswagen code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Brake lights inoperative

What Does the P0703 Volkswagen Code Mean?

This fault code is stored in the engine control module when a malfunction is detected in the brake pedal switch circuit. Two separate switches can be fitted to the vehicle or one component with both switches integrated can be fitted to the vehicle. A plausibility check is carried out between both brake pedal switches and the accelerator pedal position sensor. The configuration of the switches can be: one switch will be normally open type and the other switch will be a normally closed type. A voltage drop test can be used to validate the operation of the circuit. The signal from the switch is used by the engine control module, anti-lock brake control module and to actuate the brake lights.

P0703 Volkswagen Code - Brake Switch 'B' Circuit

Need more Information on the Code?

Need more information on how to fix the P0703 Volkswagen code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0703 Volkswagen code diagnosed by a professional: Find a repair shop in your area