Engine-Codes - Nissan - P0740 2003 Nissan Altima Sedan

P0740 2003 Nissan Altima Sedan Code - Torque Converter Clutch Solenoid Circuit Fault

- Code Popularity: 3,429 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0740 2003 Nissan Altima Sedan?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty torque converter clutch solenoid valve
  • Torque converter clutch solenoid valve harness is open or shorted
  • Torque converter clutch solenoid valve circuit poor electrical connection
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0740 2003 Nissan Altima Sedan?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0740 2003 Nissan Altima Sedan Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0740 2003 Nissan Altima Sedan code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

Diagnostic trouble code P0740 is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Transmission shift shock
  • Vehicle may not shift into the highest gear

What Does the P0740 2003 Nissan Altima Sedan Code Mean?

The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

P0740 2003 Nissan Altima Sedan Code - Torque Converter Clutch Solenoid Circuit Fault

Need more Information on the Code?

Need more information on how to fix the P0740 2003 Nissan Altima Sedan code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0740 2003 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area