Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the P1125 GMC code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The Powertrain Control Module (PCM) detects that the difference between Accelerator Pedal Position (APP) sensor 1 and APP sensor 2 is more than the predicted value.
The accelerator pedal position (APP) sensor 1 and the APP sensor 2 are potentiometer type sensors, each with the following circuits:
• A 5-volt reference circuit
• A low reference circuit
• A signal circuit
The control module provides the APP sensors with a 5-volt reference circuit and a low reference circuit. The APP sensors then provide the control module signal voltages proportional to pedal movement. The APP sensor 1 signal voltage is low at rest and increases as the pedal is depressed.
The APP sensor 2 signal voltage is low at rest and increases as the pedal is depressed. When the control module detects that the APP sensor 1 and the APP sensor 2 signal circuits are out of correlation with each other, DTC P1125 sets.
Need more information on how to fix the P1125 GMC code? Get Access to Factory Service Manuals
Get the P1125 GMC code diagnosed by a professional: Find a repair shop in your area