Engine-Codes - Toyota - P1135 Toyota

P1135 Toyota Code - Air/Fuel Ratio Sensor Heater Circuit Malfunction Bank 1 Sensor 1

- Code Popularity: 262,127 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1135 Toyota?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1
  • Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open or shorted
  • Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

Code Tech Notes













User Submitted Video

⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P1135 Toyota?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1135 Toyota Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1135 Toyota code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The P1135 is set when the Engine Control Module (ECM) detects a heated oxygen sensor heater circuit malfunction

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1135 Toyota Code Mean?

Air-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. The faster the air-fuel ratio sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

P1135 Toyota Code - Air/Fuel Ratio Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Need more Information on the Code?

Need more information on how to fix the P1135 Toyota code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1135 Toyota code diagnosed by a professional: Find a repair shop in your area