Engine-Codes - Honda - P1162 1997 Honda Civic

P1162 1997 Honda Civic Code - Air/Fuel Ratio Sensor 1 Circuit Malfunction

- Code Popularity: 2,578 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1162 1997 Honda Civic?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Air/Fuel Ratio Sensor 1
  • Air/Fuel Ratio Sensor 1 harness is open or shorted
  • Air/Fuel Ratio Sensor 1 circuit poor electrical connection
⚠ Does your Honda have Safety Recalls? → Check here

How to Fix the DTC P1162 1997 Honda Civic?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1162 1997 Honda Civic Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1162 1997 Honda Civic code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

If the element is not activated or the Engine Control Module (ECM) terminal voltage is a set value or less for at least a set time period when the power is drawn to the A/F sensor (sensor 1) heater, a malfunction is detected and the code is stored.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1162 1997 Honda Civic Code Mean?

The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM). A heater for the sensor element is embedded in the A/F sensor (sensor 1). It is activated and heats the sensor to stabilize and speed the detection of oxygen content by controlling current flowing through the heater. An increase in the current levels off as the applied voltage to the element electrode reaches a certain range because the amount of oxygen which is led through the diffusion layer is limited. The current amperage is proportional to oxygen content in the exhaust gas, so the air/fuel ratio is detected by the measurement of the current amperage. The ECM compares a set target air/fuel ratio with the detected air/fuel ratio and controls the fuel injection timing.
If the A/F sensor (sensor 1) voltage is low, the air/fuel ratio is lean, and the ECM uses A/F feedback control to issue a Rich command. If the A/F sensor (sensor 1) voltage is high, the air/fuel ratio is rich, and the ECM uses A/F feedback control to issue a Lean command.

P1162 1997 Honda Civic Code - Air/Fuel Ratio Sensor 1 Circuit Malfunction

Need more Information on the Code?

Need more information on how to fix the P1162 1997 Honda Civic code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1162 1997 Honda Civic code diagnosed by a professional: Find a repair shop in your area