Engine-Codes - Ford - P1405 2001 Ford F150

P1405 2001 Ford F150 Code - DPF EGR Sensor Circuit High Voltage Detected

- Code Popularity: 9,548 Views
- Repair Importance Level: 2/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1405 2001 Ford F150?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Differential Pressure Feedback Electronic (DPFE) sensor (EGR pressure sensor)
  • Plugged or damaged EGR tube
  • Differential Pressure Feedback Electronic (DPFE) sensor harness is open or shorted
  • Differential Pressure Feedback Electronic (DPFE) sensor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

Code Tech Notes

The EGR monitor checks the DPF EGR sensor signal to the PCM for high voltage. The test fails when the average voltage to the PCM goes to a voltage greater than the maximum calibrated value.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1405 2001 Ford F150?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1405 2001 Ford F150 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1405 2001 Ford F150 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1405 2001 Ford F150 Code Mean?

The purpose of the Exhaust Gas Recirculation (EGR) system on your engine is to limit oxides of nitrogen (NOx) emissions. This is done by redirecting small amounts of exhaust gas back through the upper intake to get mixed in with the air/fuel charge. The resultant diluted air/fuel mixture (i.e., less oxygen per cubic foot) burns cooler and combustion chamber temperatures are reduced accordingly, thereby lowering NOx emissions.
The Ford DPFE/EGR system is controlled by the Powertrain Control Module (PCM). The system employs an EGR Valve, an Electronic Vacuum Regulator (EVR), and a Delta Pressure Feedback EGR sensor (DPFE).
The DPFE Sensor measures EGR flow across an orifice located inside the special EGR Tube. The orifice is positioned between two hose ports coming off the tube which is connected to the DPFE sensor with special heat-resistant hoses. When the EGR Valve is open, a pressure differential is created across the orifice (intake manifold pressure vs. exhaust pressure). By design, this difference in pressure is measured by the DPFE sensor in terms of voltage. The DPFE voltage signal output to the PCM is directly proportional to the flow of exhaust gas entering the intake manifold.
P1405 2001 Ford F150 Code - DPF EGR Sensor Circuit High Voltage Detected

Need more Information on the Code?

Need more information on how to fix the P1405 2001 Ford F150 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1405 2001 Ford F150 code diagnosed by a professional: Find a repair shop in your area