Engine-Codes - Ford - P2072 2010 Ford Fusion

P2072 2010 Ford Fusion Code - Throttle Actuator Control System - Ice Blockage

- Code Popularity: 1,764 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P2072 2010 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Ice or oil in the intake air system could be the result of a positive crankcase ventilation (PCV) system concern

Code Tech Notes

Do not install a new electronic throttle body (ETB) for this DTC. Check the PCV system for evidence of water or ice. Disconnect the intake air fresh air plenum from the throttle body. Check for water or oily residue at the PCV fresh air port. Disconnect the tube at the valve cover and check the tube for ice obstruction/ice. Start the engine and, to check the PCV system, place a piece of cardboard on the crankcase vent in the rocker cover. If the cardboard is held on the crankcase vent and fumes are not exiting, reconnect the tube to the valve cover and the intake air port. If the test passes, the PCV system is OK. If the cardboard is not held in place, turn off the engine and check the PCV valve side of the system for ice or obstruction and repair as necessary. If no obstruction is found there, isolate and repair any obstruction in the intake manifold connection. If no obstruction is found there, make sure the PCV coolant heater is functional and repair as necessary. If no concern is present, make sure the PCV valve is allowing the correct vacuum flow and repair as necessary.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P2072 2010 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P2072 2010 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P2072 2010 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Long engine start

What Does the P2072 2010 Ford Fusion Code Mean?

The P2072 code only identifies that the strategy has carried out several open and close cycles to remove potential ice build up. This code does not imply any system concerns, only that the mode has occurred, and that mode may be causing a long start time.

P2072 2010 Ford Fusion Code - Throttle Actuator Control System - Ice Blockage

Need more Information on the Code?

Need more information on how to fix the P2072 2010 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2072 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area