• Register
Ask OBDII Question

Tech Challenge

Take the Engine-Codes.com Tech Challenge and test your car repair knowledge

Start Challenge
Engine Light ON?

The Engine-Codes.com ELM327 WiFi Car Diagnostic connects to your Android phone, iPhone, iPad, or Windows computer from your vehicle.
Get Yours Now!

20,968 questions

10,640 answers

630 comments

8,524 users

Top Users

Reynaldo (4016 Points)
G37driver (3104 Points)
OBDIITech (2396 Points)
milonajo1 (737 Points)
OBDtech2 (165 Points)
corvette-78 (127 Points)
knowledge 1488 (124 Points)
Samat Bekov (117 Points)
ptl (113 Points)
sabtele (112 Points)

P0338 Transmission replaced cause this code

I just had my transmission replaced on my Chrysler 300c. My car started sputtering and stalling, so I checked for codes and this P0338 came up. I was just wondering could the mechanic possibly caused this problem with the flywheel sensor?

Vehicle: 2005, Chrysler, 300 C, 5.7
asked Dec 4, 2013 by B Douglas

1 Answer

If there was no problem with the car before it may have been caused by the weak battery. Reset the code and if does not come back then everything is ok.

 

Possible causes
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
answered Dec 6, 2013 by G37driver (3,104 points)

Related questions

Home - About Engine-Codes - Privacy Policy - Terms and Conditions - Copyright 2010- Engine-Codes.com

Engine-Codes.com - PerfectMats.com - TheAutoMedia.com
HelpForCars.net - Infinitihelp.com - Nissanhelp.com - CarZoneAutoRepair.com

...